Ppe Kit Full Form in Marathi
The European Commission is currently working on the revision of Directive 89/686/EEC. The revision examines the scope of the Directive, conformity assessment procedures and technical requirements for market surveillance. It will also adapt the Directive to the new legal framework. The European Commission is expected to publish its proposal in 2013. It will then be examined by the European Parliament and the Council of the European Union under the ordinary legislative procedure before being published in the Official Journal of the European Union and entering into force. This form of PPE is global and refers to the different costumes and uniforms worn to protect the user from damage. Lab coats worn by scientists and ballistic vests worn by law enforcement officers and worn regularly would fall into this category. Entire sets of PPE worn together in a combination suit also fall into this category. Research studies in the form of randomized controlled trials and simulation studies are needed to determine the types of PPE that are most effective in preventing the transmission of infectious diseases to medical personnel.  Occupational skin conditions such as contact dermatitis, skin cancer and other skin lesions and infections are the second most common form of occupational disease and can be very costly.  Skin risks leading to occupational skin diseases can be divided into four groups. Chemical agents can come into contact with the skin through direct contact with contaminated surfaces, aerosol deposit, immersion or splashing.
 Physical agents such as extreme temperatures and ultraviolet or sun exposure can damage the skin with prolonged exposure.  Mechanical trauma occurs in the form of friction, pressure, abrasions, lacerations and bruises.  Biological agents such as parasites, microorganisms, plants and animals may have different effects when exposed to the skin.  Any form of PPE that acts as a barrier between the skin and the exposure agent can be considered skin protection. Since a lot of work is done with the hands, gloves are an essential part of skin protection. Some examples of gloves commonly used as PPE include rubber gloves, cut-resistant gloves, chainsaw gloves, and heat-resistant gloves. For sports and other recreational activities, many different gloves are used for protection, usually against mechanical trauma. Athletes often wear protective equipment. Studies of injuries to professional athletes, such as NFL players, question the effectiveness of existing personal protective equipment.
Early PSAs such as bulletproof vests, boots, and gloves focused on protecting the wearer`s body from physical injury. Sixteenth-century plague physicians in Europe also wore protective uniforms consisting of a long robe, helmet, glass eye coverings, gloves, and boots (see plague doctor costume) to prevent infection in the treatment of plague victims. These were made of a thick material, which was then covered with wax to make it water repellent. A mask with a beak-like structure was filled with flowers, herbs and fragrant spices to prevent the spread of miasmas, the pre-scientific belief in bad odors that spread disease through the air.  In recent years, it is widely believed that scientific personal protective equipment began with the cloth face masks promoted by Wu Lien-the during the Manchurian pneumonic plague epidemic of 1910-11, although many Western medical professionals doubted the effectiveness of face masks in preventing the spread of the disease.  Personal protective equipment falling within the scope of the Directive must comply with the essential health and safety requirements set out in Annex II to the Directive. In order to facilitate compliance with these requirements, harmonised standards for the design and manufacture of the product are drawn up at European or international level by the European Committee for Standardisation (CEN, CENELEC) and the International Organisation for Standardisation. The application of harmonised standards is voluntary and confers a presumption of conformity. However, manufacturers may choose another method to meet the requirements of the Directive. Personal protective equipment can be classified according to the protected body area, types of hazard, and type of clothing or accessory. A single element – boots, for example – can provide several forms of protection: a steel toecap and steel inserts to protect feet from crushing or puncture injuries, waterproof rubber and liner to protect against water and chemicals, high resistance to reflection and heat to protect against radiant heat, and high electrical resistance to protect against electric shock. The protective properties of each device must be weighed against the hazards that can be expected in the workplace.
More breathable types of personal protective equipment may not result in more contamination, but they will lead to greater user satisfaction.  OHS practices can use hazard control measures and interventions to mitigate workplace hazards that pose a threat to the safety and quality of life of workers.